What whole-home rewiring involves

Most houses around here were wired for a different century. The work starts with finding out what is actually there. With whole-home rewiring, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

Most of the time the job is smaller than the worst case people read about online. We find the actual fault, fix that, and leave the parts of the system that are working alone.

Where this comes up

Panels, rewires, outlets, lighting and the circuits behind everything in a house. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

Previous work is the wild card. Plenty of Illinois homes and shops have circuits somebody extended on a weekend, splices buried in a wall with no box, and breakers upsized to stop a nuisance trip. We find those first, because they decide what is safe to build on.

How we do it

Licensed and insured on every call. No job is too small to do properly, and no shortcut is worth an inspector’s red tag. We would rather do it once.

Why this is worth doing properly

A bad electrical connection does not fail politely. It heats, it chars the box around it, and eventually starts a fire inside a wall where nobody can see it. That is why the licensing exists and why an inspector looks at the work. Every connection has to be tight, every conductor sized for the load it will actually carry, every box accessible afterwards.

The cost of doing it right the first time is almost always lower than the cost of doing it twice. We would rather tell you the job is bigger than you hoped than come back in two years.

Scheduling and how long it takes

The electrician you talk to on the phone decides how urgent it is. If it is unsafe, we come the same day. If it can wait, we book it within a few days at a time that works for you.

A job that looks simple can stretch once a wall is open. If we find something that adds a day, you hear about it that afternoon, along with the reason and what it changes about the finish date.

Code, permits and inspection

Unincorporated areas usually fall under the county for permits instead of a village. The process, the paperwork and the inspection schedule can all differ, so the first question on any permitted job is simply who has jurisdiction at that address.

We deal with whichever jurisdiction the job sits in. We pull the permit, we schedule the inspection, and we are there when the inspector walks it. You get the paperwork at the end, which matters when you sell the building or when an insurer asks.

Materials and why they matter

Devices are not all the same. A fifty-cent backstabbed outlet holds the conductor with a spring clip; a commercial-grade one clamps it under a screw plate. The second kind is a couple of dollars more and it is the reason the connection is still tight in fifteen years.

We use commercial-grade devices as standard. It is a small share of the job cost and it is the part most likely to fail if you go cheap on it.

What to do before we arrive

If an outlet or switch is sparking or scorched, leave it alone and turn off its breaker. Do not pull the plug from a device that is visibly burning at the receptacle. Keep people and pets out of that room until we get there.

If a breaker tripped, note which one, and leave it off if it trips again on reset. Tell us when you call.