What office lighting involves

Lighting is the part of an electrical system people actually look at. The work starts with finding out what is actually there. With office lighting, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

You see the problem before you see a price. We point to what we found, explain why it matters and then tell you what fixing it takes. No pressure to approve on the spot.

Where this comes up

Interior, exterior, parking lots, athletic fields and the controls that run them. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

A home sale is often when this surfaces. An inspector flags aluminum branch wiring, a fuse box or a panel with doubled-up breakers, and suddenly there is a deadline. We can tell you which items are urgent and which are only noted.

How we do it

We work like it is our own house. Drop cloths go down, the power stays off only as long as it has to, and the work is finished to code with the permit closed out where the village requires one.

Why this is worth doing properly

Whoever works on your system next will trust what they find. If the panel labels are accurate and every splice is in an accessible box, they can work safely and quickly. If somebody cut corners, the next electrician spends hours tracing circuits, or worse, assumes a circuit is dead when it is not. Doing the work properly protects people you will never meet.

The cost of doing it right the first time is almost always lower than the cost of doing it twice. We would rather tell you the job is bigger than you hoped than come back in two years.

Scheduling and how long it takes

Same-day for emergencies, any day of the week. For scheduled work, plan on a few days of lead time, longer only when a permit has to be issued or ComEd has to cut and restore power.

A small repair is usually one visit. A service upgrade has several moving parts: our install, the village inspection and ComEd restoring power. We tell you which step you are waiting on at every point, so the date never goes quiet.

What the permit actually buys you

A permit puts the work on the public record for the address. When the building changes hands, that record is evidence the electrical was done and checked. Without it, a buyer's inspector treats everything they find as suspect.

It also means the work was sized and installed to the code edition in force, not to whatever was normal when the building went up.

Grounding and bonding

Grounding is the part nobody sees and the part that decides whether a fault clears safely. The ground path has to be continuous and low-impedance from every device back to the service, and the neutral and ground can only be bonded together in one place.

A neutral bonded to ground in a subpanel is one of the most common defects we find. It works right up until it does not, and then it puts current on metal that people touch.

The warning signs people ignore

The signs that get ignored are the quiet ones. A faint smell of warm plastic near the panel that comes and goes. An outlet so loose the plugs fall out. Discoloration on a receptacle face. None of these stop the house from working, which is exactly why they get put off.

A faint smell that comes and goes is worth a call. Overheating insulation gives off that smell well before anything is visibly scorched.

Lighting is a wiring problem first

Most lighting complaints are not about the fixture. They are about how many circuits are available, where the switches are, whether the dimmer matches the driver in the lamp, and whether the boxes can carry the weight of what is going on them.

Retrofitting LED into fittings designed for incandescent introduces its own issues, usually flicker or buzz from a dimmer that was never meant for an electronic load.