What load balancing involves

The service is where the building meets the grid. Everything else is downstream. The work starts with finding out what is actually there. With load balancing, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

It starts with a look at the panel and the circuits involved. From there we tell you what has to be done, what can wait and what was never a problem at all.

Where this comes up

Services, switchgear, transformers and the distribution behind the meter. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

Older buildings in this part of Illinois were wired to a different standard. Aluminum branch circuits, knob-and-tube in the walls, panels that were full the day they were installed. Those turn up constantly and they change the job.

How we do it

Quik Wire Electric has 3 years in business and 10 years of electrical experience behind it. The work goes in to code, gets tested and comes with a 100% satisfaction guarantee.

Why it usually cannot wait

Electrical problems do not stay the same size. A loose connection heats up, the heat oxidizes the metal, the oxidized metal raises the resistance, and the resistance makes more heat. That loop runs in one direction only and it ends at a scorched box.

If something is tripping, buzzing, warm to the touch or smells like hot plastic, that is the system telling you where the problem is while it is still cheap to fix.

How we quote it

Pricing a job means knowing what the service can carry, what shape the existing wiring is in and what the permit will require. None of that can be answered without somebody standing in front of the equipment.

We keep quotes simple to read: each item, what it covers and its price. If something comes up on site that the quote did not cover, you hear about it from us before it becomes part of the bill.

What the permit actually buys you

A permit puts the work on the public record for the address. When the building changes hands, that record is evidence the electrical was done and checked. Without it, a buyer's inspector treats everything they find as suspect.

It also means the work was sized and installed to the code edition in force, not to whatever was normal when the building went up.

Copper, aluminum and what is in your walls

Aluminum branch wiring went into a lot of houses in the late sixties and early seventies. It is not automatically dangerous, but it expands and contracts more than copper, which loosens terminations over time, and it needs devices and connectors rated for it.

The repair is usually not a full rewire. Proper connectors at every termination, done thoroughly, solves most of it. Anybody quoting you a whole-house rewire on sight has not looked.

When to stop and call

If a breaker trips again right after you reset it, leave it off and call. Same if a faceplate feels warm to the touch or the panel is humming. Resetting a breaker over and over is how a small fault becomes a fire.

After water gets into a panel, a fixture box or an outdoor outlet, stop using those circuits until they have been checked. Wet terminations corrode, and corroded connections heat up long after everything looks dry again.

Service size is a ceiling on everything

The service is the limit every other circuit lives under. A 100-amp service was generous when houses had one air conditioner and a gas range. Add electric cooking, a heat pump, a car charger and a finished basement and it stops being enough.

Upgrading means coordinating with ComEd, replacing the meter socket and mast, and sizing the new panel for what the building will need in ten years rather than exactly what it needs today.