Working across McHenry County

McHenry County runs from small villages to established suburbs, and the electrical work reflects that. Older housing stock means panel and service work. Newer development means EV chargers, dedicated circuits and commercial build-outs.

We cover every one of the 27 municipalities listed below with the same crew and the same license. A job in the smallest village runs the same way a job in the largest one does.

Who calls us here

Homeowners with a panel that is full or a circuit that died. Businesses that need lighting, power for equipment or a build-out finished on schedule. Villages and school districts that need a licensed contractor who documents the work.

Permits across the county

Permitting is handled municipality by municipality in McHenry County, not county-wide. We deal with each one as it comes, pull what is required and meet the inspector.

What we see go wrong

Most of the bad work we find was not done by an electrician. It was a handyman, a previous owner or somebody who watched a video. Backstabbed outlets, undersized conductors, missing grounds, neutrals and grounds bonded in a subpanel, junctions buried inside a wall with no box.

None of that is visible from the living room. It surfaces during a remodel, a home inspection, or the day a breaker stops holding.

What happens when we are done

When the work wraps up, you get a short rundown in plain language of what we found, what we fixed, and anything that can wait but belongs on your list. The panel gets labeled and the work area gets swept before we go.

Where a permit was pulled you get the closed inspection. Where documentation exists, you get it.

Code, permits and inspection

Most permitted jobs have two inspections. The rough-in is checked with the walls open, before insulation and drywall. The final happens once devices are in and the power is on. Missing the rough-in means opening finished walls later, so we schedule around it from the start.

We deal with whichever jurisdiction the job sits in. We pull the permit, we schedule the inspection, and we are there when the inspector walks it. You get the paperwork at the end, which matters when you sell the building or when an insurer asks.

What to do before we arrive

Write down which breakers you already flipped and in what order. If several are off now, leave them that way rather than trying to put things back. It is faster for us to work from a known state than to undo guesses.

Do not try to open the panel or take a device apart. Just tell us what you noticed and when, and we will take it from there.