What stadium lighting involves

Classrooms, gyms and kitchens each carry a different electrical load. The work starts with finding out what is actually there. With stadium lighting, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

Where repair makes more sense than replacement, we repair. Swapping out equipment that still has years left in it is good business for a contractor and a bad deal for you.

Where this comes up

Summer-window work in classrooms, gyms, kitchens and athletic facilities. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

Insulation is the quiet problem. Cloth-wrapped conductors from decades ago go brittle inside the box, and they crack the moment somebody moves them to swap a switch. A small job becomes a careful one, so we check before we promise a time.

How we do it

Quik Wire Electric has 3 years in business and 10 years of electrical experience behind it. The work goes in to code, gets tested and comes with a 100% satisfaction guarantee.

What we see go wrong

Most of the bad work we find was not done by an electrician. It was a handyman, a previous owner or somebody who watched a video. Backstabbed outlets, undersized conductors, missing grounds, neutrals and grounds bonded in a subpanel, junctions buried inside a wall with no box.

None of that is visible from the living room. It surfaces during a remodel, a home inspection, or the day a breaker stops holding.

What happens when we are done

Before we leave, everything we installed or repaired gets tested under load. Then we walk you through what we did, show you the panel, and point out anything we noticed that you should keep an eye on. You know what was done and why.

Where a permit was pulled you get the closed inspection. Where documentation exists, you get it.

What the permit actually buys you

A permit puts the work on the public record for the address. When the building changes hands, that record is evidence the electrical was done and checked. Without it, a buyer's inspector treats everything they find as suspect.

It also means the work was sized and installed to the code edition in force, not to whatever was normal when the building went up.

Copper, aluminum and what is in your walls

Aluminum branch wiring went into a lot of houses in the late sixties and early seventies. It is not automatically dangerous, but it expands and contracts more than copper, which loosens terminations over time, and it needs devices and connectors rated for it.

The repair is usually not a full rewire. Proper connectors at every termination, done thoroughly, solves most of it. Anybody quoting you a whole-house rewire on sight has not looked.

When to stop and call

Stop using a circuit and call if you see scorching around an outlet or switch, smell hot plastic, hear buzzing from a panel or a device, or feel warmth on a faceplate or breaker.

Lights that brighten in one room while they dim in another point to a loose neutral, often at the service or the panel. That one can push high voltage into anything plugged in. Turn off sensitive equipment and call the same day.