What distribution panels involves

Commercial electrical work gets judged on two things: does it pass, and did it delay the trade behind you. The work starts with finding out what is actually there. With distribution panels, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

You see the problem before you see a price. We point to what we found, explain why it matters and then tell you what fixing it takes. No pressure to approve on the spot.

Where this comes up

Build-outs, tenant work, lighting and three-phase power for buildings that cannot go dark. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

Previous work is the wild card. Plenty of Illinois homes and shops have circuits somebody extended on a weekend, splices buried in a wall with no box, and breakers upsized to stop a nuisance trip. We find those first, because they decide what is safe to build on.

How we do it

Licensed electricians, to code, cleaned up behind us. Where the village requires a permit we pull it and we meet the inspector, so the work is on record and it passes.

Why it usually cannot wait

Electrical problems do not stay the same size. A loose connection heats up, the heat oxidizes the metal, the oxidized metal raises the resistance, and the resistance makes more heat. That loop runs in one direction only and it ends at a scorched box.

If something is tripping, buzzing, warm to the touch or smells like hot plastic, that is the system telling you where the problem is while it is still cheap to fix.

How we quote it

When there is more than one way to do the job, the quote says so. A subpanel or a new service, repair or replace: you see both options priced, with our honest read on which one your building actually needs.

You get a written quote with the work broken into items, so you can compare it, question it or ask us to adjust the scope. Once you approve it, that is the job. Changes only happen with your say-so.

What the permit actually buys you

A permit puts the work on the public record for the address. When the building changes hands, that record is evidence the electrical was done and checked. Without it, a buyer's inspector treats everything they find as suspect.

It also means the work was sized and installed to the code edition in force, not to whatever was normal when the building went up.

Grounding and bonding

Grounding is the part nobody sees and the part that decides whether a fault clears safely. The ground path has to be continuous and low-impedance from every device back to the service, and the neutral and ground can only be bonded together in one place.

A neutral bonded to ground in a subpanel is one of the most common defects we find. It works right up until it does not, and then it puts current on metal that people touch.

What to do before we arrive

Whole house dark? Check whether the neighbors still have lights. If the street is out, that is a ComEd call, not ours. If it is only your building, leave the main off if you already shut it and wait for us.

If a breaker tripped, note which one, and leave it off if it trips again on reset. Tell us when you call.