What interior lighting involves

The wiring in an older Illinois house was never sized for how people live now. The work starts with finding out what is actually there. With interior lighting, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

Where repair makes more sense than replacement, we repair. Swapping out equipment that still has years left in it is good business for a contractor and a bad deal for you.

Where this comes up

Panels, rewires, outlets, lighting and the circuits behind everything in a house. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

Older buildings in this part of Illinois were wired to a different standard. Aluminum branch circuits, knob-and-tube in the walls, panels that were full the day they were installed. Those turn up constantly and they change the job.

How we do it

Quik Wire Electric has 3 years in business and 10 years of electrical experience behind it. The work goes in to code, gets tested and comes with a 100% satisfaction guarantee.

What we see go wrong

Most of the bad work we find was not done by an electrician. It was a handyman, a previous owner or somebody who watched a video. Backstabbed outlets, undersized conductors, missing grounds, neutrals and grounds bonded in a subpanel, junctions buried inside a wall with no box.

None of that is visible from the living room. It surfaces during a remodel, a home inspection, or the day a breaker stops holding.

What happens when we are done

You will not find offcuts in the attic or a panel cover left leaning against the wall. When we finish, the circuits are tested and labeled in the panel and the space is clean. If you have questions about anything we did, ask before we pull away.

Where a permit was pulled you get the closed inspection. Where documentation exists, you get it.

Code, permits and inspection

Code is a minimum, written so that the next person in the wall finds something safe. We build to it on every job, and where a permit applies, the inspection proves it. The paperwork stays with the building, which matters most when you sell.

We deal with whichever jurisdiction the job sits in. We pull the permit, we schedule the inspection, and we are there when the inspector walks it. You get the paperwork at the end, which matters when you sell the building or when an insurer asks.

Copper, aluminum and what is in your walls

Aluminum branch wiring went into a lot of houses in the late sixties and early seventies. It is not automatically dangerous, but it expands and contracts more than copper, which loosens terminations over time, and it needs devices and connectors rated for it.

The repair is usually not a full rewire. Proper connectors at every termination, done thoroughly, solves most of it. Anybody quoting you a whole-house rewire on sight has not looked.

What to do before we arrive

Leave the panel cover on. Flipping a breaker is fine. Taking the dead front off to look inside is not, because the service conductors at the top stay live even with the main off. We will open it when we get there.

Do not try to open the panel or take a device apart. Just tell us what you noticed and when, and we will take it from there.