What landscape lighting involves

Homeowners usually call us after something stops working twice. The work starts with finding out what is actually there. With landscape lighting, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

Most of the time the job is smaller than the worst case people read about online. We find the actual fault, fix that, and leave the parts of the system that are working alone.

Where this comes up

Panels, rewires, outlets, lighting and the circuits behind everything in a house. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

Commercial spaces change hands and change uses. A storefront becomes an auto shop, an office becomes a gym, and the wiring stays what the first tenant needed. When the new equipment shows up, the old circuits are usually the first thing that has to change.

How we do it

Licensed electricians, to code, cleaned up behind us. Where the village requires a permit we pull it and we meet the inspector, so the work is on record and it passes.

Why this is worth doing properly

Cheap electrical work usually gets paid for twice. The first time is the low price. The second is when an inspector, a buyer’s home inspection or a failed device finds what was skipped, and somebody has to open the walls back up to fix it. Doing it right the first time is the less expensive path, even when the first number is higher.

The cost of doing it right the first time is almost always lower than the cost of doing it twice. We would rather tell you the job is bigger than you hoped than come back in two years.

Scheduling and how long it takes

Call in the middle of the night with a dead panel and someone answers. Call on a Tuesday about adding outlets and you will likely see us within a few days, sooner if the schedule allows.

The quote comes with the honest version of the timeline: how long the work itself takes, plus how long we expect to wait on a permit or an inspection. Those are two separate numbers and we give you both.

The inspection is the point

An inspection is an independent check that what went behind the drywall matches what was supposed to. Work that passes has been verified by somebody with no stake in the invoice.

That is also why we would rather you hire a licensed contractor than the cheapest number you can find. Unpermitted electrical work is a problem you inherit, and it usually surfaces at the worst moment.

Grounding and bonding

Grounding is the part nobody sees and the part that decides whether a fault clears safely. The ground path has to be continuous and low-impedance from every device back to the service, and the neutral and ground can only be bonded together in one place.

A neutral bonded to ground in a subpanel is one of the most common defects we find. It works right up until it does not, and then it puts current on metal that people touch.

When to stop and call

Stop and call when you see sparks from an outlet, smell burning plastic, or notice a cord or plug that has softened or melted. Turn off that circuit at the panel if you can do it safely.

Stop and call when a fuse keeps blowing and the fix has become a bigger fuse. That swap lets the wire carry more current than it was ever sized for, and the wire becomes the weakest point in the circuit instead of the fuse.