What automatic transfer switches involves

A generator is only worth what it does in the first ten seconds of an outage. The work starts with finding out what is actually there. With automatic transfer switches, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

The first step is finding out what is actually wrong. Sometimes it is one loose connection at a device, and the fix is an hour. We will tell you that plainly instead of selling a bigger job.

Where this comes up

Standby generators, automatic transfer switches and emergency power systems. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

Ungrounded two-wire circuits are still common, along with three-prong outlets installed on top of them with no ground behind the plate. The outlet looks right. The tester says otherwise, and that changes how the job is planned.

How we do it

One crew handles residential, commercial and municipal work, so the person in your basement has seen harder jobs than yours. Everything goes in to code and passes inspection where one is required.

Why it usually cannot wait

Electrical problems do not stay the same size. A loose connection heats up, the heat oxidizes the metal, the oxidized metal raises the resistance, and the resistance makes more heat. That loop runs in one direction only and it ends at a scorched box.

If something is tripping, buzzing, warm to the touch or smells like hot plastic, that is the system telling you where the problem is while it is still cheap to fix.

How we quote it

Every quote starts with a visit. An electrician looks at the panel, the service size and the circuits involved, and asks what you plan to add over the next few years. The price you get reflects the building you actually have rather than a guess about a typical one.

We keep quotes simple to read: each item, what it covers and its price. If something comes up on site that the quote did not cover, you hear about it from us before it becomes part of the bill.

The inspection is the point

An inspection is an independent check that what went behind the drywall matches what was supposed to. Work that passes has been verified by somebody with no stake in the invoice.

That is also why we would rather you hire a licensed contractor than the cheapest number you can find. Unpermitted electrical work is a problem you inherit, and it usually surfaces at the worst moment.

Grounding and bonding

Grounding is the part nobody sees and the part that decides whether a fault clears safely. The ground path has to be continuous and low-impedance from every device back to the service, and the neutral and ground can only be bonded together in one place.

A neutral bonded to ground in a subpanel is one of the most common defects we find. It works right up until it does not, and then it puts current on metal that people touch.

The warning signs people ignore

Older homes hide their warnings in plain sight. Two-prong outlets with adapters stuck in them, extension cords that became permanent, a fuse that keeps getting replaced. Each one is the house telling you the wiring has fallen behind how you use it.

Getting used to it is the risk. A quirk you have lived with for a year is still a fault, only an older one.

The transfer switch is the system

People buy a generator and think of the engine as the product. The part that decides whether backup power actually works is the transfer switch, because it is what keeps generator power from backfeeding onto the utility line where it can kill a lineman.

Automatic switches sense the outage and start the unit without anybody being home. Manual switches cost less and need somebody present. Which one is right depends on what you are protecting.