What industrial electrical contracting involves

Industrial electrical work runs at voltages that do not forgive shortcuts. The work starts with finding out what is actually there. With industrial electrical contracting, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

Honest answer first. If what you have is fine, we say it is fine. If it needs work, we tell you how much and why, with the urgent parts separated from the ones that can wait.

Where this comes up

Motor controls, machinery wiring, 480V systems and plant distribution. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

Older buildings in this part of Illinois were wired to a different standard. Aluminum branch circuits, knob-and-tube in the walls, panels that were full the day they were installed. Those turn up constantly and they change the job.

How we do it

The electrician who quotes the job comes from the same crew that does it. We work to the current code, test every circuit before we leave and label the panel so the next person can read it.

Why this is worth doing properly

Electrical problems are slow. A loose termination can heat and cool thousands of times before it finally fails, and by then the damage is inside the box, the insulation and sometimes the framing around it. Proper work is about the long run: wire sized correctly for the load and every connection made the way the manufacturer and the code intend.

The cost of doing it right the first time is almost always lower than the cost of doing it twice. We would rather tell you the job is bigger than you hoped than come back in two years.

Scheduling and how long it takes

Same day for anything unsafe, like no power or a burning smell. A service upgrade starts as soon as the permit and ComEd allow, and most other work fits in within a few days.

If you are coordinating with other trades, tell us early. Rough-in has to happen before insulation and drywall, and the inspection has to happen before the walls close. We fit into that sequence rather than holding it up.

What the permit actually buys you

A permit puts the work on the public record for the address. When the building changes hands, that record is evidence the electrical was done and checked. Without it, a buyer's inspector treats everything they find as suspect.

It also means the work was sized and installed to the code edition in force, not to whatever was normal when the building went up.

Copper, aluminum and what is in your walls

Aluminum branch wiring went into a lot of houses in the late sixties and early seventies. It is not automatically dangerous, but it expands and contracts more than copper, which loosens terminations over time, and it needs devices and connectors rated for it.

The repair is usually not a full rewire. Proper connectors at every termination, done thoroughly, solves most of it. Anybody quoting you a whole-house rewire on sight has not looked.

The warning signs people ignore

Older homes hide their warnings in plain sight. Two-prong outlets with adapters stuck in them, extension cords that became permanent, a fuse that keeps getting replaced. Each one is the house telling you the wiring has fallen behind how you use it.

A problem that fixes itself has not gone away. It has only stopped showing up for now, and the cause is still sitting behind the plate.