What motion sensors involves

Most lighting complaints are about the wrong light in the wrong place, not the bulb. The work starts with finding out what is actually there. With motion sensors, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

You see the problem before you see a price. We point to what we found, explain why it matters and then tell you what fixing it takes. No pressure to approve on the spot.

Where this comes up

Interior, exterior, parking lots, athletic fields and the controls that run them. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

Previous work is the wild card. Plenty of Illinois homes and shops have circuits somebody extended on a weekend, splices buried in a wall with no box, and breakers upsized to stop a nuisance trip. We find those first, because they decide what is safe to build on.

How we do it

Licensed electricians, to code, cleaned up behind us. Where the village requires a permit we pull it and we meet the inspector, so the work is on record and it passes.

What we see go wrong

Most of the bad work we find was not done by an electrician. It was a handyman, a previous owner or somebody who watched a video. Backstabbed outlets, undersized conductors, missing grounds, neutrals and grounds bonded in a subpanel, junctions buried inside a wall with no box.

None of that is visible from the living room. It surfaces during a remodel, a home inspection, or the day a breaker stops holding.

What happens when we are done

Finished means tested and labeled. A panel directory that matches reality matters, because years from now someone will open that door and trust what is written there. We make sure it is right before we go.

Where a permit was pulled you get the closed inspection. Where documentation exists, you get it.

The inspection is the point

An inspection is an independent check that what went behind the drywall matches what was supposed to. Work that passes has been verified by somebody with no stake in the invoice.

That is also why we would rather you hire a licensed contractor than the cheapest number you can find. Unpermitted electrical work is a problem you inherit, and it usually surfaces at the worst moment.

Copper, aluminum and what is in your walls

Aluminum branch wiring went into a lot of houses in the late sixties and early seventies. It is not automatically dangerous, but it expands and contracts more than copper, which loosens terminations over time, and it needs devices and connectors rated for it.

The repair is usually not a full rewire. Proper connectors at every termination, done thoroughly, solves most of it. Anybody quoting you a whole-house rewire on sight has not looked.

When to stop and call

Stop and call when you see sparks from an outlet, smell burning plastic, or notice a cord or plug that has softened or melted. Turn off that circuit at the panel if you can do it safely.

Once a breaker has tripped three or four times in a week, the troubleshooting phase is over. Unplugging things and moving loads around only hides the pattern. Leave it off and have an electrician find what is actually overloading it or faulting.

Lighting is a wiring problem first

Most lighting complaints are not about the fixture. They are about how many circuits are available, where the switches are, whether the dimmer matches the driver in the lamp, and whether the boxes can carry the weight of what is going on them.

Retrofitting LED into fittings designed for incandescent introduces its own issues, usually flicker or buzz from a dimmer that was never meant for an electronic load.