What construction electrical involves

Code corrections are what happen when somebody skipped this step earlier. The work starts with finding out what is actually there. With construction electrical, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

Honest answer first. If what you have is fine, we say it is fine. If it needs work, we tell you how much and why, with the urgent parts separated from the ones that can wait.

Where this comes up

Code corrections, permits, load calculations, design-build and utility coordination. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

It comes up most during a remodel. The walls are open, the old wiring is right there, and it is the cheapest moment the building will ever give you to fix what is behind them. Once the drywall is back, the same repair costs more.

How we do it

One crew handles residential, commercial and municipal work, so the person in your basement has seen harder jobs than yours. Everything goes in to code and passes inspection where one is required.

What we see go wrong

Most of the bad work we find was not done by an electrician. It was a handyman, a previous owner or somebody who watched a video. Backstabbed outlets, undersized conductors, missing grounds, neutrals and grounds bonded in a subpanel, junctions buried inside a wall with no box.

None of that is visible from the living room. It surfaces during a remodel, a home inspection, or the day a breaker stops holding.

What happens when we are done

We test before we call it finished, every time. If something does not test right, we fix it while we are still there. Then the panel gets labeled, the scraps leave with us, and you get a clear account of the job.

Where a permit was pulled you get the closed inspection. Where documentation exists, you get it.

What the permit actually buys you

A permit puts the work on the public record for the address. When the building changes hands, that record is evidence the electrical was done and checked. Without it, a buyer's inspector treats everything they find as suspect.

It also means the work was sized and installed to the code edition in force, not to whatever was normal when the building went up.

Grounding and bonding

Grounding is the part nobody sees and the part that decides whether a fault clears safely. The ground path has to be continuous and low-impedance from every device back to the service, and the neutral and ground can only be bonded together in one place.

A neutral bonded to ground in a subpanel is one of the most common defects we find. It works right up until it does not, and then it puts current on metal that people touch.

What to do before we arrive

If there is a burning smell and you can safely reach the panel, shut off the affected circuit. If you cannot identify it, shut off the main. Do not run extension cords from another circuit as a workaround, especially for anything that heats.

Do not try to open the panel or take a device apart. Just tell us what you noticed and when, and we will take it from there.