What athletic field lighting involves

Most lighting complaints are about the wrong light in the wrong place, not the bulb. The work starts with finding out what is actually there. With athletic field lighting, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

Most of the time the job is smaller than the worst case people read about online. We find the actual fault, fix that, and leave the parts of the system that are working alone.

Where this comes up

Interior, exterior, parking lots, athletic fields and the controls that run them. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

New load on old wiring is the most common version. A heat pump or a charger for the car goes in, the circuits that were fine until then start complaining, and the real question becomes whether the existing service can carry it at all.

How we do it

Licensed electricians, to code, cleaned up behind us. Where the village requires a permit we pull it and we meet the inspector, so the work is on record and it passes.

What we see go wrong

Most of the bad work we find was not done by an electrician. It was a handyman, a previous owner or somebody who watched a video. Backstabbed outlets, undersized conductors, missing grounds, neutrals and grounds bonded in a subpanel, junctions buried inside a wall with no box.

None of that is visible from the living room. It surfaces during a remodel, a home inspection, or the day a breaker stops holding.

What happens when we are done

Most panels we open have labels that stopped being true years ago. Ours come out accurate. Every circuit we work on is tested and named in the panel directory, so the next electrician, or you at midnight with a tripped breaker, knows exactly what is what.

Where a permit was pulled you get the closed inspection. Where documentation exists, you get it.

The inspection is the point

An inspection is an independent check that what went behind the drywall matches what was supposed to. Work that passes has been verified by somebody with no stake in the invoice.

That is also why we would rather you hire a licensed contractor than the cheapest number you can find. Unpermitted electrical work is a problem you inherit, and it usually surfaces at the worst moment.

Copper, aluminum and what is in your walls

Aluminum branch wiring went into a lot of houses in the late sixties and early seventies. It is not automatically dangerous, but it expands and contracts more than copper, which loosens terminations over time, and it needs devices and connectors rated for it.

The repair is usually not a full rewire. Proper connectors at every termination, done thoroughly, solves most of it. Anybody quoting you a whole-house rewire on sight has not looked.

The warning signs people ignore

A tingle from a metal appliance or a faucet. Bulbs that burn out far faster in one fixture than anywhere else. A buzz you only hear at night when the house is quiet. These get filed under strange things about the house. They are faults, and they deserve a look before they become emergencies.

Warm is a warning. A switch, outlet or breaker should never feel hot, and heat at a device means current is fighting a bad connection.

Lighting is a wiring problem first

Most lighting complaints are not about the fixture. They are about how many circuits are available, where the switches are, whether the dimmer matches the driver in the lamp, and whether the boxes can carry the weight of what is going on them.

Retrofitting LED into fittings designed for incandescent introduces its own issues, usually flicker or buzz from a dimmer that was never meant for an electronic load.