What commercial electrical repair involves

When the power goes down in a business, the clock starts on lost revenue. The work starts with finding out what is actually there. With commercial electrical repair, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

We explain the job in plain terms before anything starts: what we are changing, why, and how long the power will be off. If a smaller fix does the job, that is the fix you get.

Where this comes up

Build-outs, tenant work, lighting and three-phase power for buildings that cannot go dark. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

A home sale is often when this surfaces. An inspector flags aluminum branch wiring, a fuse box or a panel with doubled-up breakers, and suddenly there is a deadline. We can tell you which items are urgent and which are only noted.

How we do it

We work like it is our own house. Drop cloths go down, the power stays off only as long as it has to, and the work is finished to code with the permit closed out where the village requires one.

Why this is worth doing properly

A bad electrical connection does not fail politely. It heats, it chars the box around it, and eventually starts a fire inside a wall where nobody can see it. That is why the licensing exists and why an inspector looks at the work. Every connection has to be tight, every conductor sized for the load it will actually carry, every box accessible afterwards.

The cost of doing it right the first time is almost always lower than the cost of doing it twice. We would rather tell you the job is bigger than you hoped than come back in two years.

Scheduling and how long it takes

Call in the middle of the night with a dead panel and someone answers. Call on a Tuesday about adding outlets and you will likely see us within a few days, sooner if the schedule allows.

A small repair is usually one visit. A service upgrade has several moving parts: our install, the village inspection and ComEd restoring power. We tell you which step you are waiting on at every point, so the date never goes quiet.

The inspection is the point

An inspection is an independent check that what went behind the drywall matches what was supposed to. Work that passes has been verified by somebody with no stake in the invoice.

That is also why we would rather you hire a licensed contractor than the cheapest number you can find. Unpermitted electrical work is a problem you inherit, and it usually surfaces at the worst moment.

Copper, aluminum and what is in your walls

Aluminum branch wiring went into a lot of houses in the late sixties and early seventies. It is not automatically dangerous, but it expands and contracts more than copper, which loosens terminations over time, and it needs devices and connectors rated for it.

The repair is usually not a full rewire. Proper connectors at every termination, done thoroughly, solves most of it. Anybody quoting you a whole-house rewire on sight has not looked.

What to do before we arrive

If an outlet or switch is sparking or scorched, leave it alone and turn off its breaker. Do not pull the plug from a device that is visibly burning at the receptacle. Keep people and pets out of that room until we get there.

If a breaker tripped, note which one, and leave it off if it trips again on reset. Tell us when you call.