What lighting maintenance involves

Most electrical emergencies were visible months earlier. The work starts with finding out what is actually there. With lighting maintenance, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

Plenty of calls end with a smaller bill than people braced for. A tripping breaker is often a single bad device, and a dead outlet is often a loose wire two boxes away.

Where this comes up

Inspections, preventive maintenance and emergency repairs around the clock. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

Older Illinois buildings rarely match the drawings, if there are drawings at all. Circuits wander between floors, junction boxes hide above ceilings, and a single breaker might feed a bedroom and half the kitchen. Tracing it properly is the first hour of a lot of jobs.

How we do it

Quik Wire Electric has 3 years in business and 10 years of electrical experience behind it. The work goes in to code, gets tested and comes with a 100% satisfaction guarantee.

Why this is worth doing properly

Electrical work is the kind you only see when it goes wrong. A connection that was never tightened properly, a splice with no box around it, a breaker larger than the wire behind it: all of it looks fine for years. Doing it properly means it stays fine, and the inspection is the independent check that the work was done the way it should be.

The cost of doing it right the first time is almost always lower than the cost of doing it twice. We would rather tell you the job is bigger than you hoped than come back in two years.

Scheduling and how long it takes

Once a job is booked, the work itself usually goes quickly. The waiting, when there is any, comes from permit offices and ComEd scheduling, which is why a service change takes longer to start than a repair does.

We will tell you at the quote which parts we control and which parts we do not. A service upgrade waiting on a utility appointment is a different timeline from a panel swap we can do tomorrow.

What the permit actually buys you

A permit puts the work on the public record for the address. When the building changes hands, that record is evidence the electrical was done and checked. Without it, a buyer's inspector treats everything they find as suspect.

It also means the work was sized and installed to the code edition in force, not to whatever was normal when the building went up.

Copper, aluminum and what is in your walls

Aluminum branch wiring went into a lot of houses in the late sixties and early seventies. It is not automatically dangerous, but it expands and contracts more than copper, which loosens terminations over time, and it needs devices and connectors rated for it.

The repair is usually not a full rewire. Proper connectors at every termination, done thoroughly, solves most of it. Anybody quoting you a whole-house rewire on sight has not looked.

When to stop and call

If a breaker trips again right after you reset it, leave it off and call. Same if a faceplate feels warm to the touch or the panel is humming. Resetting a breaker over and over is how a small fault becomes a fire.

After water gets into a panel, a fixture box or an outdoor outlet, stop using those circuits until they have been checked. Wet terminations corrode, and corroded connections heat up long after everything looks dry again.