What utility coordination involves

Code corrections are what happen when somebody skipped this step earlier. The work starts with finding out what is actually there. With utility coordination, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

Where repair makes more sense than replacement, we repair. Swapping out equipment that still has years left in it is good business for a contractor and a bad deal for you.

Where this comes up

Code corrections, permits, load calculations, design-build and utility coordination. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

It comes up most during a remodel. The walls are open, the old wiring is right there, and it is the cheapest moment the building will ever give you to fix what is behind them. Once the drywall is back, the same repair costs more.

How we do it

Quik Wire Electric has 3 years in business and 10 years of electrical experience behind it. The work goes in to code, gets tested and comes with a 100% satisfaction guarantee.

What we see go wrong

Most of the bad work we find was not done by an electrician. It was a handyman, a previous owner or somebody who watched a video. Backstabbed outlets, undersized conductors, missing grounds, neutrals and grounds bonded in a subpanel, junctions buried inside a wall with no box.

None of that is visible from the living room. It surfaces during a remodel, a home inspection, or the day a breaker stops holding.

What happens when we are done

Before we leave, everything we installed or repaired gets tested under load. Then we walk you through what we did, show you the panel, and point out anything we noticed that you should keep an eye on. You know what was done and why.

Where a permit was pulled you get the closed inspection. Where documentation exists, you get it.

Code, permits and inspection

Code is a minimum, written so that the next person in the wall finds something safe. We build to it on every job, and where a permit applies, the inspection proves it. The paperwork stays with the building, which matters most when you sell.

We deal with whichever jurisdiction the job sits in. We pull the permit, we schedule the inspection, and we are there when the inspector walks it. You get the paperwork at the end, which matters when you sell the building or when an insurer asks.

Copper, aluminum and what is in your walls

Aluminum branch wiring went into a lot of houses in the late sixties and early seventies. It is not automatically dangerous, but it expands and contracts more than copper, which loosens terminations over time, and it needs devices and connectors rated for it.

The repair is usually not a full rewire. Proper connectors at every termination, done thoroughly, solves most of it. Anybody quoting you a whole-house rewire on sight has not looked.

The warning signs people ignore

A breaker you reset and forget about. A switch that crackles when you flip it. A light that flickers only when the dryer runs. People live with these for months because nothing seems broken yet. They are early warnings, and early is the cheap time to fix them.

Getting used to it is the risk. A quirk you have lived with for a year is still a fault, only an older one.