What HVAC electrical involves

When the power goes down in a business, the clock starts on lost revenue. The work starts with finding out what is actually there. With HVAC electrical, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

Honest answer first. If what you have is fine, we say it is fine. If it needs work, we tell you how much and why, with the urgent parts separated from the ones that can wait.

Where this comes up

Build-outs, tenant work, lighting and three-phase power for buildings that cannot go dark. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

Older buildings in this part of Illinois were wired to a different standard. Aluminum branch circuits, knob-and-tube in the walls, panels that were full the day they were installed. Those turn up constantly and they change the job.

How we do it

Quik Wire Electric has 3 years in business and 10 years of electrical experience behind it. The work goes in to code, gets tested and comes with a 100% satisfaction guarantee.

Why it usually cannot wait

Electrical problems do not stay the same size. A loose connection heats up, the heat oxidizes the metal, the oxidized metal raises the resistance, and the resistance makes more heat. That loop runs in one direction only and it ends at a scorched box.

If something is tripping, buzzing, warm to the touch or smells like hot plastic, that is the system telling you where the problem is while it is still cheap to fix.

How we quote it

Every quote starts with a visit. An electrician looks at the panel, the service size and the circuits involved, and asks what you plan to add over the next few years. The price you get reflects the building you actually have rather than a guess about a typical one.

A quote from us is a written list of the work and the price for it. Nothing gets added quietly. If something behind a wall changes the job, you see it and decide before we go on.

Code, permits and inspection

Most permitted jobs have two inspections. The rough-in is checked with the walls open, before insulation and drywall. The final happens once devices are in and the power is on. Missing the rough-in means opening finished walls later, so we schedule around it from the start.

We deal with whichever jurisdiction the job sits in. We pull the permit, we schedule the inspection, and we are there when the inspector walks it. You get the paperwork at the end, which matters when you sell the building or when an insurer asks.

Copper, aluminum and what is in your walls

Aluminum branch wiring went into a lot of houses in the late sixties and early seventies. It is not automatically dangerous, but it expands and contracts more than copper, which loosens terminations over time, and it needs devices and connectors rated for it.

The repair is usually not a full rewire. Proper connectors at every termination, done thoroughly, solves most of it. Anybody quoting you a whole-house rewire on sight has not looked.

What to do before we arrive

If water is anywhere near the panel or an outlet, do not touch either one. Stay out of the wet area, keep everyone back, and call us. A flooded basement with live circuits is a job for us, not for a pair of rubber boots.

Clear a path to the panel and the problem area. Then jot down anything that seems to set it off, like a certain appliance or time of day.