What exit lighting involves

Commercial electrical work gets judged on two things: does it pass, and did it delay the trade behind you. The work starts with finding out what is actually there. With exit lighting, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

We tell you what we find before we tell you what it costs. If the scope is smaller than you expected, it gets smaller. That happens more often than people assume.

Where this comes up

Build-outs, tenant work, lighting and three-phase power for buildings that cannot go dark. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

New load on old wiring is the most common version. A heat pump or a charger for the car goes in, the circuits that were fine until then start complaining, and the real question becomes whether the existing service can carry it at all.

How we do it

Licensed and insured on every call. No job is too small to do properly, and no shortcut is worth an inspector’s red tag. We would rather do it once.

What we see go wrong

Most of the bad work we find was not done by an electrician. It was a handyman, a previous owner or somebody who watched a video. Backstabbed outlets, undersized conductors, missing grounds, neutrals and grounds bonded in a subpanel, junctions buried inside a wall with no box.

None of that is visible from the living room. It surfaces during a remodel, a home inspection, or the day a breaker stops holding.

What happens when we are done

Finished means tested and labeled. A panel directory that matches reality matters, because years from now someone will open that door and trust what is written there. We make sure it is right before we go.

Where a permit was pulled you get the closed inspection. Where documentation exists, you get it.

What the permit actually buys you

A permit puts the work on the public record for the address. When the building changes hands, that record is evidence the electrical was done and checked. Without it, a buyer's inspector treats everything they find as suspect.

It also means the work was sized and installed to the code edition in force, not to whatever was normal when the building went up.

Copper, aluminum and what is in your walls

Aluminum branch wiring went into a lot of houses in the late sixties and early seventies. It is not automatically dangerous, but it expands and contracts more than copper, which loosens terminations over time, and it needs devices and connectors rated for it.

The repair is usually not a full rewire. Proper connectors at every termination, done thoroughly, solves most of it. Anybody quoting you a whole-house rewire on sight has not looked.

What to do before we arrive

Whole house dark? Check whether the neighbors still have lights. If the street is out, that is a ComEd call, not ours. If it is only your building, leave the main off if you already shut it and wait for us.

If a breaker tripped, note which one, and leave it off if it trips again on reset. Tell us when you call.