What sports lighting involves

Most lighting complaints are about the wrong light in the wrong place, not the bulb. The work starts with finding out what is actually there. With sports lighting, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

We explain the job in plain terms before anything starts: what we are changing, why, and how long the power will be off. If a smaller fix does the job, that is the fix you get.

Where this comes up

Interior, exterior, parking lots, athletic fields and the controls that run them. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

New load on old wiring is the most common version. A heat pump or a charger for the car goes in, the circuits that were fine until then start complaining, and the real question becomes whether the existing service can carry it at all.

How we do it

Licensed electricians, to code, cleaned up behind us. Where the village requires a permit we pull it and we meet the inspector, so the work is on record and it passes.

Why it usually cannot wait

Electrical problems do not stay the same size. A loose connection heats up, the heat oxidizes the metal, the oxidized metal raises the resistance, and the resistance makes more heat. That loop runs in one direction only and it ends at a scorched box.

If something is tripping, buzzing, warm to the touch or smells like hot plastic, that is the system telling you where the problem is while it is still cheap to fix.

How we quote it

When there is more than one way to do the job, the quote says so. A subpanel or a new service, repair or replace: you see both options priced, with our honest read on which one your building actually needs.

No lump sums. Every quote is broken out so you can see where the money goes, and it is tied to a defined scope. When the scope holds, the price holds.

Code, permits and inspection

An inspector is checking the things you cannot easily see later: box fill, conductor size, grounding and bonding, clearances at the panel, and whether each circuit has the protection it needs. Passing means a second trained set of eyes agrees the work is safe.

We deal with whichever jurisdiction the job sits in. We pull the permit, we schedule the inspection, and we are there when the inspector walks it. You get the paperwork at the end, which matters when you sell the building or when an insurer asks.

Copper, aluminum and what is in your walls

Aluminum branch wiring went into a lot of houses in the late sixties and early seventies. It is not automatically dangerous, but it expands and contracts more than copper, which loosens terminations over time, and it needs devices and connectors rated for it.

The repair is usually not a full rewire. Proper connectors at every termination, done thoroughly, solves most of it. Anybody quoting you a whole-house rewire on sight has not looked.

What to do before we arrive

If an outlet or switch is sparking or scorched, leave it alone and turn off its breaker. Do not pull the plug from a device that is visibly burning at the receptacle. Keep people and pets out of that room until we get there.

Leave the affected circuit off if it smells hot or keeps tripping. Otherwise, just remember what you were using when it acted up.

Lighting is a wiring problem first

Most lighting complaints are not about the fixture. They are about how many circuits are available, where the switches are, whether the dimmer matches the driver in the lamp, and whether the boxes can carry the weight of what is going on them.

Retrofitting LED into fittings designed for incandescent introduces its own issues, usually flicker or buzz from a dimmer that was never meant for an electronic load.