What new home electrical wiring involves

The wiring in an older Illinois house was never sized for how people live now. The work starts with finding out what is actually there. With new home electrical wiring, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

The first step is finding out what is actually wrong. Sometimes it is one loose connection at a device, and the fix is an hour. We will tell you that plainly instead of selling a bigger job.

Where this comes up

Panels, rewires, outlets, lighting and the circuits behind everything in a house. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

Ungrounded two-wire circuits are still common, along with three-prong outlets installed on top of them with no ground behind the plate. The outlet looks right. The tester says otherwise, and that changes how the job is planned.

How we do it

Quik Wire Electric has 3 years in business and 10 years of electrical experience behind it. The work goes in to code, gets tested and comes with a 100% satisfaction guarantee.

Why this is worth doing properly

Insurance companies and home buyers both ask about electrical work eventually. Unpermitted wiring can complicate a claim or a sale, and a panel full of mismatched breakers can stall a closing. Work that was permitted and inspected, with the paperwork kept, answers those questions on one sheet of paper. That is a lot easier than explaining a mystery circuit years after the fact.

The cost of doing it right the first time is almost always lower than the cost of doing it twice. We would rather tell you the job is bigger than you hoped than come back in two years.

Scheduling and how long it takes

Emergency calls get same-day attention. Scheduled work usually starts within a few days, though a job needing a permit or a utility disconnect runs on the village's calendar and ComEd's, not purely on ours.

Permit turnaround is not the same in every village. Some issue one quickly and others take longer, especially for anything bigger than a circuit. We know to ask, and we factor that wait into the date we give you.

The inspection is the point

An inspection is an independent check that what went behind the drywall matches what was supposed to. Work that passes has been verified by somebody with no stake in the invoice.

That is also why we would rather you hire a licensed contractor than the cheapest number you can find. Unpermitted electrical work is a problem you inherit, and it usually surfaces at the worst moment.

Copper, aluminum and what is in your walls

Aluminum branch wiring went into a lot of houses in the late sixties and early seventies. It is not automatically dangerous, but it expands and contracts more than copper, which loosens terminations over time, and it needs devices and connectors rated for it.

The repair is usually not a full rewire. Proper connectors at every termination, done thoroughly, solves most of it. Anybody quoting you a whole-house rewire on sight has not looked.

When to stop and call

If a breaker trips again right after you reset it, leave it off and call. Same if a faceplate feels warm to the touch or the panel is humming. Resetting a breaker over and over is how a small fault becomes a fire.

After water gets into a panel, a fixture box or an outdoor outlet, stop using those circuits until they have been checked. Wet terminations corrode, and corroded connections heat up long after everything looks dry again.