What photocells involves

Most lighting complaints are about the wrong light in the wrong place, not the bulb. The work starts with finding out what is actually there. With photocells, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

Where repair makes more sense than replacement, we repair. Swapping out equipment that still has years left in it is good business for a contractor and a bad deal for you.

Where this comes up

Interior, exterior, parking lots, athletic fields and the controls that run them. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

It comes up most during a remodel. The walls are open, the old wiring is right there, and it is the cheapest moment the building will ever give you to fix what is behind them. Once the drywall is back, the same repair costs more.

How we do it

We show up when we said we would and explain the work before we start. Permits get pulled where they are required, and the job is not finished until it passes inspection.

Why this is worth doing properly

For a business, a shortcut in the electrical shows up as downtime. A circuit that trips during the busiest hour or a cooler that loses power overnight can cost more than the original job did. Getting the load calculation right and every connection tight at install is what prevents that, and it is the part of the work customers never see.

The cost of doing it right the first time is almost always lower than the cost of doing it twice. We would rather tell you the job is bigger than you hoped than come back in two years.

Scheduling and how long it takes

Most scheduled jobs start within a few days. Anything needing a village permit or a utility disconnect waits on those offices, and we will tell you up front how long that usually takes. Emergencies skip the line and get same-day attention.

Parts can set the pace. Common breakers and devices are on the truck. Larger gear, like a specific panel or a transfer switch, may have to be ordered, and we will tell you that at the quote instead of on the day.

Code, permits and inspection

Code is a minimum, written so that the next person in the wall finds something safe. We build to it on every job, and where a permit applies, the inspection proves it. The paperwork stays with the building, which matters most when you sell.

We deal with whichever jurisdiction the job sits in. We pull the permit, we schedule the inspection, and we are there when the inspector walks it. You get the paperwork at the end, which matters when you sell the building or when an insurer asks.

Copper, aluminum and what is in your walls

Aluminum branch wiring went into a lot of houses in the late sixties and early seventies. It is not automatically dangerous, but it expands and contracts more than copper, which loosens terminations over time, and it needs devices and connectors rated for it.

The repair is usually not a full rewire. Proper connectors at every termination, done thoroughly, solves most of it. Anybody quoting you a whole-house rewire on sight has not looked.

When to stop and call

If a breaker trips again right after you reset it, leave it off and call. Same if a faceplate feels warm to the touch or the panel is humming. Resetting a breaker over and over is how a small fault becomes a fire.

After water gets into a panel, a fixture box or an outdoor outlet, stop using those circuits until they have been checked. Wet terminations corrode, and corroded connections heat up long after everything looks dry again.

Lighting is a wiring problem first

Most lighting complaints are not about the fixture. They are about how many circuits are available, where the switches are, whether the dimmer matches the driver in the lamp, and whether the boxes can carry the weight of what is going on them.

Retrofitting LED into fittings designed for incandescent introduces its own issues, usually flicker or buzz from a dimmer that was never meant for an electronic load.