What LED lighting involves

Good lighting is a wiring problem before it is a fixture problem. The work starts with finding out what is actually there. With LED lighting, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

Plenty of calls end with a smaller bill than people braced for. A tripping breaker is often a single bad device, and a dead outlet is often a loose wire two boxes away.

Where this comes up

Interior, exterior, parking lots, athletic fields and the controls that run them. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

Older buildings in this part of Illinois were wired to a different standard. Aluminum branch circuits, knob-and-tube in the walls, panels that were full the day they were installed. Those turn up constantly and they change the job.

How we do it

Straight to the point: we find the problem, fix it to code and leave the space as clean as we found it. Anything that needs a permit gets one, and gets inspected.

What changes with an older building

Buildings in this part of Illinois cover about a century of wiring practice. Knob-and-tube in the oldest, cloth-insulated branch circuits after that, aluminum wiring in a stretch of the sixties and seventies, and modern copper since. Each one fails differently and each one has its own repair path.

We look at what is actually in the walls before quoting, because guessing from the year the house was built is how people end up with a surprise halfway through.

Who actually shows up

No job is too small for the real crew. Whether it is a single switch or a municipal facility, a licensed electrician from Quik Wire Electric does the work start to finish. None of it gets passed to a subcontractor.

We give you a name and a time window when we book. Running behind happens, and when it does, you get a phone call about it.

Code, permits and inspection

Past work without a permit sometimes surfaces when we pull one. An inspector looking at a new circuit may notice an older addition that was never inspected. If that happens, we explain the options and what it takes to bring the earlier work into compliance.

We deal with whichever jurisdiction the job sits in. We pull the permit, we schedule the inspection, and we are there when the inspector walks it. You get the paperwork at the end, which matters when you sell the building or when an insurer asks.

Grounding and bonding

Grounding is the part nobody sees and the part that decides whether a fault clears safely. The ground path has to be continuous and low-impedance from every device back to the service, and the neutral and ground can only be bonded together in one place.

A neutral bonded to ground in a subpanel is one of the most common defects we find. It works right up until it does not, and then it puts current on metal that people touch.

What to do before we arrive

If the panel itself is hot, buzzing or smells, do not touch it at all. Shut off the main only if you can reach it without leaning on the box. Otherwise keep clear and tell us that when you call.

Write down when the problem started and what else was running at the time. Those two details save a lot of searching.

Lighting is a wiring problem first

Most lighting complaints are not about the fixture. They are about how many circuits are available, where the switches are, whether the dimmer matches the driver in the lamp, and whether the boxes can carry the weight of what is going on them.

Retrofitting LED into fittings designed for incandescent introduces its own issues, usually flicker or buzz from a dimmer that was never meant for an electronic load.