What level 2 charging involves

Commercial electrical work gets judged on two things: does it pass, and did it delay the trade behind you. The work starts with finding out what is actually there. With level 2 charging, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

The first step is finding out what is actually wrong. Sometimes it is one loose connection at a device, and the fix is an hour. We will tell you that plainly instead of selling a bigger job.

Where this comes up

Build-outs, tenant work, lighting and three-phase power for buildings that cannot go dark. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

Insulation is the quiet problem. Cloth-wrapped conductors from decades ago go brittle inside the box, and they crack the moment somebody moves them to swap a switch. A small job becomes a careful one, so we check before we promise a time.

How we do it

The electrician who quotes the job comes from the same crew that does it. We work to the current code, test every circuit before we leave and label the panel so the next person can read it.

What we see go wrong

Most of the bad work we find was not done by an electrician. It was a handyman, a previous owner or somebody who watched a video. Backstabbed outlets, undersized conductors, missing grounds, neutrals and grounds bonded in a subpanel, junctions buried inside a wall with no box.

None of that is visible from the living room. It surfaces during a remodel, a home inspection, or the day a breaker stops holding.

What happens when we are done

We test before we call it finished, every time. If something does not test right, we fix it while we are still there. Then the panel gets labeled, the scraps leave with us, and you get a clear account of the job.

Where a permit was pulled you get the closed inspection. Where documentation exists, you get it.

What the permit actually buys you

A permit puts the work on the public record for the address. When the building changes hands, that record is evidence the electrical was done and checked. Without it, a buyer's inspector treats everything they find as suspect.

It also means the work was sized and installed to the code edition in force, not to whatever was normal when the building went up.

Copper, aluminum and what is in your walls

Aluminum branch wiring went into a lot of houses in the late sixties and early seventies. It is not automatically dangerous, but it expands and contracts more than copper, which loosens terminations over time, and it needs devices and connectors rated for it.

The repair is usually not a full rewire. Proper connectors at every termination, done thoroughly, solves most of it. Anybody quoting you a whole-house rewire on sight has not looked.

What to do before we arrive

If the panel itself is hot, buzzing or smells, do not touch it at all. Shut off the main only if you can reach it without leaning on the box. Otherwise keep clear and tell us that when you call.

Do not try to open the panel or take a device apart. Just tell us what you noticed and when, and we will take it from there.