What emergency power testing involves

Most electrical emergencies were visible months earlier. The work starts with finding out what is actually there. With emergency power testing, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

It starts with a look at the panel and the circuits involved. From there we tell you what has to be done, what can wait and what was never a problem at all.

Where this comes up

Inspections, preventive maintenance and emergency repairs around the clock. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

Ungrounded two-wire circuits are still common, along with three-prong outlets installed on top of them with no ground behind the plate. The outlet looks right. The tester says otherwise, and that changes how the job is planned.

How we do it

The electrician who quotes the job comes from the same crew that does it. We work to the current code, test every circuit before we leave and label the panel so the next person can read it.

Why it usually cannot wait

Electrical problems do not stay the same size. A loose connection heats up, the heat oxidizes the metal, the oxidized metal raises the resistance, and the resistance makes more heat. That loop runs in one direction only and it ends at a scorched box.

If something is tripping, buzzing, warm to the touch or smells like hot plastic, that is the system telling you where the problem is while it is still cheap to fix.

How we quote it

If somebody prices your job without seeing it, they are guessing, and the guess gets corrected later on your bill. We would rather come out, look at the actual equipment and quote from that.

Every quote lists the work line by line, so you can see what you are paying for, and it describes the scope in plain terms. If the job turns out bigger than that scope, we stop and talk to you first.

The inspection is the point

An inspection is an independent check that what went behind the drywall matches what was supposed to. Work that passes has been verified by somebody with no stake in the invoice.

That is also why we would rather you hire a licensed contractor than the cheapest number you can find. Unpermitted electrical work is a problem you inherit, and it usually surfaces at the worst moment.

Copper, aluminum and what is in your walls

Aluminum branch wiring went into a lot of houses in the late sixties and early seventies. It is not automatically dangerous, but it expands and contracts more than copper, which loosens terminations over time, and it needs devices and connectors rated for it.

The repair is usually not a full rewire. Proper connectors at every termination, done thoroughly, solves most of it. Anybody quoting you a whole-house rewire on sight has not looked.

When to stop and call

Any time a device or the panel runs warm, buzzes or leaves a scorch mark, stop using that circuit. Leave it off and call us. We answer 24/7 for exactly this.

After water gets into a panel, a fixture box or an outdoor outlet, stop using those circuits until they have been checked. Wet terminations corrode, and corroded connections heat up long after everything looks dry again.