What lighting controls involves

Good lighting is a wiring problem before it is a fixture problem. The work starts with finding out what is actually there. With lighting controls, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

Most of the time the job is smaller than the worst case people read about online. We find the actual fault, fix that, and leave the parts of the system that are working alone.

Where this comes up

Interior, exterior, parking lots, athletic fields and the controls that run them. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

A home sale is often when this surfaces. An inspector flags aluminum branch wiring, a fuse box or a panel with doubled-up breakers, and suddenly there is a deadline. We can tell you which items are urgent and which are only noted.

How we do it

We work like it is our own house. Drop cloths go down, the power stays off only as long as it has to, and the work is finished to code with the permit closed out where the village requires one.

What changes with an older building

Buildings in this part of Illinois cover about a century of wiring practice. Knob-and-tube in the oldest, cloth-insulated branch circuits after that, aluminum wiring in a stretch of the sixties and seventies, and modern copper since. Each one fails differently and each one has its own repair path.

We look at what is actually in the walls before quoting, because guessing from the year the house was built is how people end up with a surprise halfway through.

Who actually shows up

You get someone who has been in tough situations and knows what they are looking at. Our crew is licensed, works on everything from homes to government facilities, and does every part of the job in-house.

You get the electrician’s name and an arrival window. If we are going to be late, we call ahead. That is the basic courtesy we would expect at our own homes.

What the permit actually buys you

A permit puts the work on the public record for the address. When the building changes hands, that record is evidence the electrical was done and checked. Without it, a buyer's inspector treats everything they find as suspect.

It also means the work was sized and installed to the code edition in force, not to whatever was normal when the building went up.

Materials and why they matter

Devices are not all the same. A fifty-cent backstabbed outlet holds the conductor with a spring clip; a commercial-grade one clamps it under a screw plate. The second kind is a couple of dollars more and it is the reason the connection is still tight in fifteen years.

We use commercial-grade devices as standard. It is a small share of the job cost and it is the part most likely to fail if you go cheap on it.

What to do before we arrive

If an outlet or switch is sparking or scorched, leave it alone and turn off its breaker. Do not pull the plug from a device that is visibly burning at the receptacle. Keep people and pets out of that room until we get there.

Leave the affected circuit off if it smells hot or keeps tripping. Otherwise, just remember what you were using when it acted up.

Lighting is a wiring problem first

Most lighting complaints are not about the fixture. They are about how many circuits are available, where the switches are, whether the dimmer matches the driver in the lamp, and whether the boxes can carry the weight of what is going on them.

Retrofitting LED into fittings designed for incandescent introduces its own issues, usually flicker or buzz from a dimmer that was never meant for an electronic load.