What electrical circuit installation involves

A house tells you when its electrical system is behind. The work starts with finding out what is actually there. With electrical circuit installation, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

We tell you what we find before we tell you what it costs. If the scope is smaller than you expected, it gets smaller. That happens more often than people assume.

Where this comes up

Panels, rewires, outlets, lighting and the circuits behind everything in a house. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

A lot of the work in Illinois starts in a house or building that has been added onto more than once. Each addition borrowed power from whatever circuit was closest, and by now nobody knows which breaker feeds what. Sorting that out is part of the job.

How we do it

Every connection gets tightened properly and every wire is sized for the load it carries. Where the village requires a permit, the inspector signs off on it, so the standard is on paper as well as in the wall.

What we see go wrong

Most of the bad work we find was not done by an electrician. It was a handyman, a previous owner or somebody who watched a video. Backstabbed outlets, undersized conductors, missing grounds, neutrals and grounds bonded in a subpanel, junctions buried inside a wall with no box.

None of that is visible from the living room. It surfaces during a remodel, a home inspection, or the day a breaker stops holding.

What happens when we are done

Most panels we open have labels that stopped being true years ago. Ours come out accurate. Every circuit we work on is tested and named in the panel directory, so the next electrician, or you at midnight with a tripped breaker, knows exactly what is what.

Where a permit was pulled you get the closed inspection. Where documentation exists, you get it.

What the permit actually buys you

A permit puts the work on the public record for the address. When the building changes hands, that record is evidence the electrical was done and checked. Without it, a buyer's inspector treats everything they find as suspect.

It also means the work was sized and installed to the code edition in force, not to whatever was normal when the building went up.

Copper, aluminum and what is in your walls

Aluminum branch wiring went into a lot of houses in the late sixties and early seventies. It is not automatically dangerous, but it expands and contracts more than copper, which loosens terminations over time, and it needs devices and connectors rated for it.

The repair is usually not a full rewire. Proper connectors at every termination, done thoroughly, solves most of it. Anybody quoting you a whole-house rewire on sight has not looked.

What to do before we arrive

Whole house dark? Check whether the neighbors still have lights. If the street is out, that is a ComEd call, not ours. If it is only your building, leave the main off if you already shut it and wait for us.

Snap a photo of the panel, the outlet or whatever looks wrong. A picture plus a short history of the problem often tells us what to bring.