What dedicated circuits involves

Commercial jobs live or die on coordination, not on wire. The work starts with finding out what is actually there. With dedicated circuits, that means looking at the existing wiring, the panel capacity and whatever the last person left behind.

Where repair makes more sense than replacement, we repair. Swapping out equipment that still has years left in it is good business for a contractor and a bad deal for you.

Where this comes up

Build-outs, tenant work, lighting and three-phase power for buildings that cannot go dark. Most of these calls come from Des Plaines and the surrounding suburbs, but we take them anywhere in our service area.

Older buildings in this part of Illinois were wired to a different standard. Aluminum branch circuits, knob-and-tube in the walls, panels that were full the day they were installed. Those turn up constantly and they change the job.

How we do it

Quik Wire Electric has 3 years in business and 10 years of electrical experience behind it. The work goes in to code, gets tested and comes with a 100% satisfaction guarantee.

What we see go wrong

Most of the bad work we find was not done by an electrician. It was a handyman, a previous owner or somebody who watched a video. Backstabbed outlets, undersized conductors, missing grounds, neutrals and grounds bonded in a subpanel, junctions buried inside a wall with no box.

None of that is visible from the living room. It surfaces during a remodel, a home inspection, or the day a breaker stops holding.

What happens when we are done

We clean up the work area and leave the place the way we found it, minus the problem. Where a permit was pulled, the inspection closes the job and you get the paperwork for your records.

Where a permit was pulled you get the closed inspection. Where documentation exists, you get it.

What the permit actually buys you

A permit puts the work on the public record for the address. When the building changes hands, that record is evidence the electrical was done and checked. Without it, a buyer's inspector treats everything they find as suspect.

It also means the work was sized and installed to the code edition in force, not to whatever was normal when the building went up.

Copper, aluminum and what is in your walls

Aluminum branch wiring went into a lot of houses in the late sixties and early seventies. It is not automatically dangerous, but it expands and contracts more than copper, which loosens terminations over time, and it needs devices and connectors rated for it.

The repair is usually not a full rewire. Proper connectors at every termination, done thoroughly, solves most of it. Anybody quoting you a whole-house rewire on sight has not looked.

When to stop and call

If something electrical is giving off heat or a smell, stop using the circuit and call. A fault you can sense from across the room is already past the early stage.

After water gets into a panel, a fixture box or an outdoor outlet, stop using those circuits until they have been checked. Wet terminations corrode, and corroded connections heat up long after everything looks dry again.